REMOVAL AND REPLACEMENT OF COMPONENTS 99
Chapter 4
To replace an optional diskette drive:
1 While lifting the green drivelock release tab, slide the drive forward into the chassis.
2 Route the diskette drive data cable between the system board and the hard drive cage. Your cable
might look different than the one shown.
CAUTION The cable must stay between the system board and the hard drive cage. It might be
necessary to push the cable down so that it catches on the system board. This routing method is
important because you do not want to interfere with the CPU heatsink fans or block airflow.
3 Connect the cables from the back of the diskette drive.
To Next Page
Loading...
