HP Z200 - Small Form Factor Workstation Setup And Configuration Guide

28
10) Go into Network Setup & select Host Name.
Enter a host name
Default Setting : None
Recommended Setting : User Dependent
Spaces are not accepted in the host name.
11) Go into Network Setup and select TCP/IP.
a. Wired LAN IPv4 Configuration
DHCP Mode
Default Setting : DHCP Enabled
Recommended Setting : User Dependent
Select Enabled.
For the purpose of this whitepaper, DHCP is enabled.
b. Wired LAN IPV6 Configuration
Select Enabled option for IPv6 Feature Selection
IPv6 Interface ID Type
Default Setting : Random ID
Recommended Setting : Random ID
RANDOM ID - The IPv6 Interface ID is automatically generated using a
random number as described in RFC 3041. This is the default.
Intel ID - The IPv6 Interface ID is automatically generated using the MAC
address.
Manual ID - The IPv6 Interface ID is configured manually. Selecting this
type requires that the Manual Interface ID is set with a valid value.
IPv6 Address
Enter a static IPv6 address
Default Setting : None
Recommended Setting : Network Dependent
Example: 2001:db8::1428:57ab
IPv6 default Router
Enter the IPv6 Default Router address
Default Setting : None
Recommended Setting : Network Dependent
Example: 2001:db8::1428:57ab
Preferred DNS IPv6 Address
Enter the Preferred DNS IPv6 Address
Default Setting : None
Recommended Setting : Network Dependent
Example: 2001:db8::1428:57ab

HP Z200 - Small Form Factor Workstation Specifications

General

Brand	HP
Model	Z200 - Small Form Factor Workstation
Category	Desktop
Language	English