31
Figure 19: Intel TLS PSK Configuration Screen
i. Go into Set PID and PPS.
Default Setting : None
Recommended Setting : System Dependent
This option is for Provisioning ID (PID) and Provisioning Passphrase (PPS)
entry. PIDs are 8 characters and PPS are 32 characters. There are dashes
between every set of four characters so counting dashes PIDs are 9
characters and PPS are 40 characters. They must be generated by an
S&CS.
The Admin Password, PID, and PPS can be pre-populated by HP during
manufacturing. Go to the OEM TLS-PSK section for details.
ii. Skip Delete PID and PPS.
This Option deletes the current PID and PPS entries in the system.
iii. Return to previous menu.
f. Skip TLS PKI.
This option is for Remote Configuration (RCFG) also known as Zero Touch
Configuration (ZTC).
This option only appears in the Factory or In-Setup phase.
Go to the RCFG Section for more information.
g. Return to previous menu.
To Next Page
Loading...
Need help?
General