Remove the cross-brace and the two
pieces of packaging material from each
end of the stand box.
Place the two pieces of packaging
material on the floor, spaced 40 cm apart,
and place the cross-brace on top of them.
A screwdriver and 22 screws are
provided in the stand box: 16 screws to
assemble the stand, 4 to attach it to the
printer, and 2 are spare.
Do not try to remove the washers from
the screws.
Note: All the screws are for the stand. The
basket does not need screws.
11 12 13
Assemble the stand
Attach a foot to each leg, using four
screws in each foot. First fit all four screws
loosely, then tighten them up.
16
Make sure you have used 4 screws
in each leg.
15
Attach the stand
Return to the main body of the printer,
carefully turn the printer upside down in
order to attach the legs.
17
14
Attach each leg of the stand to the cross-
brace, using two screws on the outside
of the leg and then two on the inside.
First fit all four screws loosely, then tighten
up the screws on the outside of the leg,
followed by the screws on the inside.
Remove the small flaps from each of the
foam end pieces.
Do not remove the foam end
pieces.
18
x8x8
4+4=8
To Next Page
Loading...