Remove the orange tape from the
transparent covering that protects
the printer.
Open the transparent covering and remove
the desiccant bag from the top
of the printer.
Lift the stand, keeping it upside down.
19 20 21
There is a round yellow button protruding
from the top of one stand leg, and a
square green button protruding from the
top of the other leg. Each button fits into a
hole in the printer.
22
Place the stand on the printer slowly and
carefully, so that the colored buttons on
the legs fit into the corresponding holes
in the printer.
Notice that the printer body is
upside down.
23
When the legs are correctly located on the
printer, attach them to the printer using two
screws for each leg.
Check that you have used a total of twenty
screws, and that all have been tightened.
You should have two screws left over,
which are spare.
24 25
Check that the wheels on the stand are
locked.
26
To Next Page
Loading...