Turning the printer over is done in two
stages. For the first stage, hold the printer
by its feet and rotate the feet until they
touch the floor.
The printer weighs 60 kg (132 lb) (24“
model) or 80 kg (167 lb) (44” model).
Now hold the printer by the foam end
pieces and by the center rear, and
continue to rotate it until it stands on its
feet, all four wheels in contact with the
floor.
Remove the foam end pieces. Remove the transparent covering from the
printer.
Note: If your printer is 24-in
without stand, go to step 41.
27
31 32 33
Turn the printer over
44:80kg
24:60kg
28 29
If the full weight of the printer rests on
the wheel lock, it may break.
If necessary, rotate the wheel.
30
The lock on each wheel should be facing
inwards (away from the floor).
Unlock the brake lever on each of the four
wheels by lifting the lever.
34
To Next Page
Loading...