Rest the basket’s rear tube on the supports
that you have just fitted to each leg of the
stand.
The basket is now complete. Remove the orange tape from the printer
window.
39 40 41
Attach the basket’s front tube to the two
short tubes on each foot.
38
Fit the two short tubes to the printer’s feet,
one on the front of each foot. Each tube
should click into place.
37
Prepare the printer
Lay out the components of the basket.
35
Fit the basket supports to the stand legs,
one to each leg.
36
Attach the basket
Open the window (printer’s top cover).
42
To Next Page
Loading...