43 44
Beside the front panel, you will see a
cardboard support attached to the printer
with tape. Remove the tape.
Turn the cardboard support 90° to the
right.
Part of the stopper may fall off while you
are removing it; in this case, remove both
parts. The stopper will not be needed
again; you can discard it.
47
Move to the rear of the printer and fit the
rear tray to the printer.
Note: The rear tray may already
be assembled (as in step 50). If
so, please remove the orange
tape from the rear tray and go to
step 51.
48
45 46
Inside the right-hand side of the printer,
you will see an orange carriage
stopper.
Release the stopper by lifting the lever
wrapped with light blue paper, then
remove the stopper from the printer.
Lift the cardboard support up and out of
the printer. It will not be needed again;
you can discard it.
Slide it in and then down.
49
Push up the back of the tray into its closed
position.
50
To Next Page
Loading...