Solid-state drive (SSD)
Description Spare part number
1 TB, PCIe, Gen3×4, NVMe, MLC 937005-001
512 GB, PCIe, Gen3×4, SS/DS, Self-encrypting Drive (SED), Opal 2, TLC 937011-001
512 GB, PCIe, Gen3×4, SS, NVMe, MLC 937010-001
512 GB, SATA-3, FIPS-140-2, TLC 937009-001
256 GB, PCIe, Gen3x4, NVMe, TLC 937008-001
256 GB, PCIe, Gen3x4, NVMe, MLC 937007-001
256 GB, SATA-3, Self-encrypting Drive (SED), Opal 2, TLC 937006-001
Before removing the solid-state drive, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 29).
5. Disconnect the battery (see Battery on page 34).
Remove the solid-state drive:
1. Remove the Phillips M2.0×3.0 screw (1) that secures the drive to the system board.
2. Remove the drive (2) by pulling it away from the connector.
NOTE: M.2 solid-state drives are designed with notches to prevent incorrect insertion.
Reverse this procedure to install the solid–state drive.
Component replacement procedures 37
To Next Page
Loading...
