HP ZR30w User Manual

Removing the Monitor Pedestal Base
You can remove the monitor panel from the pedestal base to mount the panel on a wall, a swing arm,
or other mounting fixture (purchased separately).
This monitor has a Quick Release mechanism that allows you to easily remove and replace the monitor
panel to the pedestal base.
CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the
power and signal cables are both disconnected. Also disconnect any USB cables that are connected to
the monitor.
1. Disconnect the signal, power, and USB cables from the back of the monitor.
2. Slide the Quick Release latch (1) on the pedestal base to the side (either right or left).
3. Pull up on the monitor display head (2) to remove it from the base.
Figure 3-10 Removing the Monitor from the Pedestal Base
ENWW Removing the Monitor Pedestal Base 11

HP ZR30w Specifications

General

3D	No
Pixel pitch	0.2505 x 0.2505 mm
Display surface	Matt
Display diagonal	30 \
Display resolution	2560 x 1600 pixels
Viewable size diagonal	762 mm
Contrast ratio (dynamic)	3000:1
Contrast ratio (typical)	1000:1
Display number of colors	-
Display brightness (typical)	370 cd/m²
Supported graphics resolutions	2560 x 1600 (WQXGA)
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	10 - 80 %
Product color	Black
Country of origin	China
Market positioning	Business
HDCP	Yes
USB hub version	2.0
DVI-D ports quantity	1
VGA (D-Sub) ports quantity	0
USB Type-A downstream ports quantity	5
LED indicators	Power
Tilt angle range	-5 - 35 °
Height adjustment	100 mm
Panel mounting interface	100 x 100 mm
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	2 W
Power consumption (typical)	185 W
Cables included	AC, DisplayPort, DVI, USB
Sustainability certificates	ENERGY STAR

Weight and Dimensions

Depth (with stand)	276 mm
Height (with stand)	489 mm
Depth (without stand)	87 mm
Width (without stand)	694 mm
Height (without stand)	454 mm
Weight (without stand)	13000 g