HPC LASER LIMITED – NEVER LEAVE YOUR MACHINE UNATTENDED WHEN OPERATING.
WARNING AND INFORMATION LABELS
The warning and information labels are attached in such positions of the
machine that could represent a source of danger during set-up and operation.
Therefore, follow the information on the labels. If labels are lost or damaged,
they must be replaced immediately.
Find below pictures of designated safety stickers.
This notifies the operator that the
machine WILL NOT start without
any water in the Chiller and if so the
water should be left to raise or
lower to 20⁰.
Stickers found at the very back of
the cutting machine indicate the
potential risk of laser beam hazards
and fire risks.
To Next Page
Loading...
Need help?
General