HPC LASER LIMITED – NEVER LEAVE YOUR MACHINE UNATTENDED WHEN OPERATING.
GENERAL SAFETY INFORMATION:
All people involved in the installation, set-up and training (if asked for) must of
read and totally understood the Operation Manual and in particular the
“Safety” section. The user is recommended to generate company-internal
instructions considering the professional qualifications of the personnel
employed in each case, and the receipt of the instruction/Operation Manual or
the participation at introduction/training should be acknowledged in writing in
each case.
Safety-conscious Working
The machine must ONLY be operated by trained and authorised persons. For
all activities concerning installation, set-up, start-up, operation, modifications
of conditions and methods of operation, maintenance, inspection and repair,
the switch-off procedures that may be provided in the Operation Manual must
be observed.
Laser safety goggles are available to purchase from HPC Laser. Please contact
for any information and for purchasing.
Please contact HPC Laser for any retooling, changing of workplace for advice
on what is needed and in-case of an engineer being needed to visibly see the
machine and the issue and/or change.
To Next Page
Loading...
Need help?
General