5. Power on the switch. As shown in step 3.
6. Connect network cables.
NOTE: For transceiver connections, install and use only
HPE SFP transceivers supported by the switch.
See “SFP Installation Notes” (page 3).
7. (Optional) Configure the switch for management.
By factory default, the switch will automatically obtain its IP
network configuration from a DHCP or BootP server.
Subsequently, you can determine the IP address assigned
to the switch by inspecting your DHCP/BootP server, or by
using LLDP from a connected device.
You can also manage and configure the switch through a
console port connection. Connect a VT-100 terminal or PC
(with suitable terminal emulation software) to the switch
using the serial cable (DB-9 and RJ-45 connectors) supplied
with the switch.
For information on configuration and remote management,
see the Management and Configuration Guide for your
switch. The manuals are available at http://www.hpe.com/
networking/support.
* You can also connect a console to the switch via the USB
console port (cable not provided). Use a USB 2.0 high-speed
cable with a male type A (4-pin) to male micro-B (5-pin)
connector. Maximum allowable length is 5m. For more
information on using the USB console port, see the Installation
and Getting Started Guide for your switch.
SFP Installation Notes
• Use only genuine Hewlett Packard Enterprise SFPs. Non Hewlett Packard Enterprise SFP
transceivers are not supported. Use of genuine Hewlett Packard Enterprise products ensures that
your network maintains optimal performance and reliability. Should you require additional transceivers,
contact a Hewlett Packard Enterprise sales representative or an authorized reseller.
• Hot swapping SFP transceivers. Supported SFP transceivers that you can install in your Hewlett
Packard Enterprise switch can be “hot swapped”–removed and installed while the switch is receiving
To Next Page
Loading...
