Need help?Do you have a question about the HPE FlexNetwork MSR3044 and is the answer not in the manual?
General| Product Type | Router |
|---|---|
| Model | MSR3044 |
| Product Series | HPE FlexNetwork MSR3000 |
| Form Factor | Rack-mountable |
| Connectivity Technology | Wired |
| Data Link Protocol | Ethernet, Fast Ethernet, Gigabit Ethernet |
| USB Ports | 1 x USB 2.0 |
| Power Supply | Internal power supply |
| Voltage Required | 100-240 VAC |
| Network / Transport Protocol | IP, ICMP, UDP |
| Console Port | 1 x RJ-45 |
| IPSec VPN Throughput | 600 Mbps |
| WAN Interfaces | Gigabit Ethernet (SFP/RJ-45) |
| Routing Protocols | OSPF, BGP, IS-IS, RIP-1, RIP-2 |
| Remote Management Protocol | SNMP, Telnet, SSH, HTTP, HTTPS |
| Encryption Algorithm | AES, DES, 3DES |
| Authentication Method | RADIUS, TACACS+ |
| Interfaces | 4 x Gigabit Ethernet SFP, 4 x Gigabit Ethernet RJ-45, 1 x console (RJ-45), 1 x USB 2.0 |
| Power Device | Power supply |
| Dimensions (W x D x H) | 440 x 360 x 44 mm |
| Dimensions | 440 x 360 x 44 mm |
| Operating Temperature | 0°C to 45°C |
| Operating Humidity | 10% to 90% (non-condensing) |
| Ports | 4 x Gigabit Ethernet (SFP), 4 x Gigabit Ethernet (RJ-45) |
Enables or disables debug information display for a module on the current terminal.
Tests reachability of destination IP address and displays ping statistics.
Configures parameters for Network Quality Assessment (NQA) client operations.
Applies a Power over Ethernet (PoE) profile to a power interface (PI).
Displays SNMPv1 or SNMPv2c community information.
To Next Page
