73
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-jitter
[Sysname-nqa-admin-test-udp-jitter] reaction 1 checked-element rtt threshold-type
accumulate 100 threshold-value 50 5 action-type trap-only
reaction trap
Use reaction trap to configure the sending of traps to the NMS under specific conditions.
Use undo reaction trap to restore the default.
Syntax
reaction trap { path-change | probe-failure consecutive-probe-failures | test-complete |
test-failure [ accumulate-probe-failures ] }
undo reaction trap { path-change | probe-failure | test-complete | test-failure }
Default
No traps are sent to the NMS.
Views
DHCP/DLSw/DNS/FTP/HTTP/SNMP/TCP/voice operation view
ICMP/UDP echo operation view
ICMP/UDP jitter operation view
UDP tracert operation view
Predefined user roles
network-admin
Parameters
path-change: Sends a trap when the UDP tracert operation detects a different path to the
destination.
probe-failure consecutive-probe-failures: Sends a trap to the NMS if the number of consecutive
probe failures in an operation is greater than or equal to consecutive-probe-failures. The value range
for the consecutive-probe-failures argument is 1 to 15. The system counts the number of
consecutive probe failures for each operation, so multiple traps might be sent.
test-complete: Sends a trap to indicate that the operation is completed.
test-failure: Sends a trap when an operation fails. For operations other than UDP tracert operation,
the system counts the total number of probe failures in an operation. If the number reaches or
exceeds the value for the accumulate-probe-failures argument, a trap is sent for the operation
failure.
accumulate-probe-failures: Specifies the total number of probe failures in an operation. The value
range is 1 to 15. This argument is not supported by the UDP tracert operation.
To Next Page
Loading...
Need help?
General
