EasyManuals Logo

HPE FlexNetwork MSR3044 User Manual

HPE FlexNetwork MSR3044
548 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #222 background imageLoading...
Page #222 background image
208
Syntax
In non-FIPS mode:
snmp-agent sys-info contact version { all | { v1 | v2c | v3 } * }
undo snmp-agent sys-info version { all | { v1 | v2c | v3 } * }
In FIPS mode:
snmp-agent sys-info version v3
undo snmp-agent sys-info version v3
Default
SNMPv3 is enabled.
Views
System view
Predefined user roles
network-admin
Parameters
all: Specifies SNMPv1, SNMPv2c, and SNMPv3.
v1: Specifies SNMPv1.
v2c: Specifies SNMPv2c.
v3: Specifies SNMPv3.
Usage guidelines
SNMPv1 and SNMPv2c settings in this command are not supported in FIPS mode.
Configure the SNMP agent with the same SNMP version as the NMS for successful communications
between them.
Examples
# Enable SNMPv3.
<Sysname> system-view
[Sysname] snmp-agent sys-info version v3
Related commands
display snmp-agent sys-info
snmp-agent target-host
Use snmp-agent target-host to configure an SNMP notification target host.
Use undo snmp-agent target-host to remove an SNMP notification target host.
Syntax
In non-FIPS mode:

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE FlexNetwork MSR3044 and is the answer not in the manual?

HPE FlexNetwork MSR3044 Specifications

General IconGeneral
BrandHPE
ModelFlexNetwork MSR3044
CategoryNetwork Router
LanguageEnglish

Related product manuals