486
Default
The log file saving interval is 86400 seconds.
Views
System view
Predefined user roles
network-admin
Parameters
freq-sec: Specifies the log file saving interval in seconds. The value range is 1 to 86400.
Usage guidelines
This command enables the system to automatically save logs in the log file buffer to the log file at the
specified interval.
Examples
# Set the log file saving interval to 60000 seconds.
<Sysname> system-view
[Sysname] info-center logfile frequency 60000
Related commands
info-center logfile enable
info-center logfile overwrite-protection
Use info-center logfile overwrite-protection to enable log file overwrite-protection.
Use undo info-center logfile overwrite-protection to disable log file overwrite-protection.
Syntax
info-center logfile overwrite-protection [ all-port-powerdown ]
undo info-center logfile overwrite-protection
Default
Log file overwrite-protection is disabled.
Views
System view
Predefined user roles
network-admin
Parameters
all-port-powerdown: Shuts down all the service ports on the device when the last log file is full or
the storage device runs out of space.
Usage guidelines
This command is available only in FIPS mode.
To Next Page
Loading...
Need help?
General
