497
provides a command prompt in command editing mode, or a [Y/N] string in interaction mode so you
can continue your operation from where you were stopped.
Examples
# Enable synchronous information output, and then execute the display current-configuration
command to view the current configuration of the device.
<Sysname> system-view
[Sysname] info-center synchronous
Info-center synchronous output is on
[Sysname] display current-
At this time, the system receives log information. It displays the log information first, and then
displays your previous input, which is display current- in this example.
%May 21 14:33:19:425 2007 Sysname SHELL/4/LOGIN: VTY login from 192.168.1.44
[Sysname] display current-
Enter configuration to complete the display current-configuration command, and press the
Enter key to execute the command.
# Enable synchronous information output, and then save the current configuration (enter interactive
information).
<Sysname> system-view
[Sysname] info-center synchronous
Info-center synchronous output is on
[Sysname] save
The current configuration will be written to the device. Are you sure? [Y/N]:
At this time, the system receives the log information. It displays the log information first and then
displays [Y/N].
%May 21 14:33:19:425 2007 Sysname SHELL/4/LOGIN: VTY login from 192.168.1.44
[Y/N]:
Enter Y or N to complete your input.
info-center syslog min-age
Use info-center syslog min-age to set the minimum storage period for log files and logs in the log
buffer.
Use undo info-center syslog min-age to restore the default.
Syntax
info-center syslog min-age min-age
undo info-center syslog min-age
Default
The minimum storage period for log files and logs in the log buffer is not set.
To Next Page
Loading...
Need help?
General
