108
Syntax
ntp-servicebroadcast-client
undontp-servicebroadcast-client
Default
The device does not operatein any NTP association mode.
Views
Interface view
Predefined user roles
network-admin
Usage guidelines
After you configure the command, the device listens to NTP messages sent by the NTP broadcast
server and is synchronized based on the received NTP messages.
If you have configured the device to operate in broadcast client mode on an interface with the
command, do not add the interface to any aggregate group. To add the interface to an aggregate
group, remove the configuration of the command.
Examples
# Configure the device to operatein broadcast client mode and receive NTP broadcast messages on
GigabitEthernet1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] ntp-service broadcast-client
Related commands
ntp-service broadcast-server
ntp-service broadcast-server
Use ntp-service broadcast-serverto configure the device to operatein NTP broadcast server mode
and use the current interface to send NTP broadcast packets.
Use undo ntp-service broadcast-serverto remove the configuration.
Syntax
ntp-servicebroadcast-server [ authentication-keyidkeyid|versionnumber ] *
undontp-servicebroadcast-server
Default
The device does not operatein anyNTP association mode.
Views
Interface view
To Next Page
Loading...
Need help?
General
