378
monitor kernel deadloop time
Use monitor kernel deadloop time to set the interval for identifying a kernel thread deadloop.
Use undo monitor kernel deadloop time to restore the default.
Syntax
Centralized devices in standalone mode:
monitor kernel deadloop time time
undo monitor kernel deadloop time
Distributed devices in standalone mode/centralized devices in IRF mode:
monitor kernel deadloop time time [ slot slot-number [ cpu cpu-number ] ]
undo monitor kernel deadloop time [ slot slot-number [ cpu cpu-number ] ]
Distributed devices in IRF mode:
monitor kernel deadloop time time [ chassis chassis-number slot slot-number [ cpu
cpu-number ] ]
undo monitor kernel deadloop time [ chassis chassis-number slot slot-number [ cpu
cpu-number ] ]
Default
The interval for identifying a kernel thread deadloop is 8 seconds.
Views
System view
Predefined user roles
network-admin
Parameters
time time: Specifies the interval for identifying a kernel thread deadloop, in the range of 1 to 65535
seconds.
slot slot-number: Specifies an MPU by its slot number. If you do not specify this option, the active
MPU is specified. (Distributed devices in standalone mode.)
slot slot-number: Specifies an IRF member device by its ID. If you do not specify this option, the
master device is specified. (Centralized devices in IRF mode.)
chassis chassis-number slot slot-number: Specifies an MPU on an IRF member device. If you do
not specify this option, the global active MPU is specified. (Distributed devices in IRF mode.)
cpu cpu-number: Specifies a CPU by its number. (Centralized devices in IRF mode/distributed
devices in IRF or standalone mode.)
To Next Page
Loading...
Need help?
General
