377
undo monitor kernel deadloop exclude-thread [ tid ] [ chassis chassis-number slot slot-number
[ cpu cpu-number ] ]
Default
Kernel thread deadloop detection monitors all kernel threads.
Views
System view
Predefined user roles
network-admin
Parameters
tid: Specifies a kernel thread by its ID, in the range of 1 to 2147483647. If no kernel thread is
specified for the undo command, the default is restored.
slot slot-number: Specifies an MPU by its slot number. If you do not specify this option, the active
MPU is specified. (Distributed devices in standalone mode.)
slot slot-number: Specifies an IRF member device by its ID. If you do not specify this option, the
master device is specified. (Centralized devices in IRF mode.)
chassis chassis-number slot slot-number: Specifies an MPU on an IRF member device. If you do
not specify this option, the global active MPU is specified. (Distributed devices in IRF mode.)
cpu cpu-number: Specifies a CPU by its number. (Centralized devices in IRF mode/distributed
devices in IRF or standalone mode.)
Usage guidelines
You can disable kernel thread deadloop detection for up to 128 kernel threads by executing the
command.
Inappropriate use of the command can cause service problems or system breakdown. Make sure
you understand the impact of the command on your network before you use it.
Examples
# Disable kernel thread deadloop detection for kernel thread 15.
<Sysname> system-view
[Sysname]monitor kernel deadloop exclude-thread 15
Related commands
display kernel deadloop configuration
display kernel deadloop
monitor kernel deadloop enable
monitor kernel deadloop time
To Next Page
Loading...
Need help?
General
