453
IPv6 NetStream traditional data is exported to all destination hosts in system view. IPv6 NetStream
aggregation data is exported to all destination hosts in the related aggregation view. If you expect
only IPv6 NetStream aggregation data, specify destination hosts only in the IPv6 NetStream
aggregation mode view. Aggregation data export reduces bandwidth usage.
Examples
# In system view, specify 40::1 as the IP address of the destination host and UDP port 5000 as the
export destination port number.
<Sysname> system-view
[Sysname] ipv6 netstream export host 40::1 5000
# In AS aggregation mode view, specify 40::1 as the IP address of the destination host and UDP port
6000 as the export destination port number.
<Sysname> system-view
[Sysname] ipv6 netstream aggregation as
[Sysname-ns6-aggregation-as] ipv6 netstream export host 40::1 6000
Related commands
ipv6 netstream aggregation
ipv6 netstream export source
ipv6 netstream export rate
Use ipv6 netstream export rate to limit the IPv6 NetStream data export rate.
Use undo ipv6 netstream export rate to restore the default.
Syntax
ipv6 netstream export rate rate
undo ipv6 netstream export rate
Default
The export rate of IPv6 NetStream data is not limited.
Views
System view
Predefined user roles
network-admin
Parameters
rate: Specifies the maximum number of packets to be exported per second. The value range is 1 to
1000.
Examples
# Allow a maximum of 10 packets to be exported per second.
<Sysname> system-view
To Next Page
Loading...
Need help?
General
