19
Views
DHCP/DLSw/DNS/SNMP/TCP/voice operation view
ICMP/UDP echo operation view
ICMP/path/UDP jitter operation view
UDP tracert operation view
Predefined user roles
network-admin
Parameters
ip-address: Specifies the destination IPv4 address for the operation.
Examples
# Specify 10.1.1.1 as the destination IPv4 address for the ICMP echo operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] destination ip 10.1.1.1
destination ipv6
Use destination ipv6 to configure the destination IPv6 address for the operation.
Use undo destination ipv6 to restore the default.
Syntax
destination ipv6 ipv6-address
undo destination ipv6
Default
No destination IPv6 address is configured for an operation.
Views
ICMP echo operation view
Predefined user roles
network-admin
Parameters
ipv6-address: Specifies the destination IPv6 address for the operation. IPv6 link-local addresses are
not supported.
Examples
# In ICMP echo operation view, specify 1::1 as the destination IPv6 address for ICMP echo requests.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
To Next Page
Loading...
Need help?
General
