455
ipv6 netstream export v9-template refresh-rate packet
Use ipv6 netstream export v9-template refresh-rate packet to configure the refresh frequency (in
packets) for IPv6 NetStream version 9 templates. The templates are sent after the specified number
of packets are sent.
Use undo ipv6 netstream export v9-template refresh-rate packet to restore the default.
Syntax
ipv6 netstream export v9-template refresh-rate packet packets
undo ipv6 netstream export v9-template refresh-rate packet
Default
Version 9 templates are sent every 20 packets.
Views
System view
Predefined user roles
network-admin
Parameters
packets: Specifies the number of packets that are sent before version 9 templates are sent to
NetStream servers for an update. The value range is 1 to 600.
Usage guidelines
Version 9 is template-based and supports user-defined formats. An IPv6 NetStream device must
send the version 9 templates to NetStream servers regularly, because the servers do not
permanently save templates.
You can configure the refresh frequency or refresh interval for the device to send version 9 templates.
If both settings are configured, templates are sent when either of the conditions is met.
To configure the refresh interval for version 9 templates, use the ipv6 netstream export
v9-template refresh-rate time command.
Examples
# Configure the device to send IPv6 NetStream version 9 templates every 100 packets.
<Sysname> system-view
[Sysname] ipv6 netstream export v9-template refresh-rate packet 100
Related commands
ipv6 netstream export v9-template refresh-rate time
To Next Page
Loading...
Need help?
General
