97
display ntp-service sessions
Use display ntp-service sessionsto display information about all IPv4 NTP associations.
Syntax
display ntp-service sessions [verbose]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
verbose: Displays detailed information aboutall IPv4 NTP associations. If you do not specify this
keyword, the command displays only brief information aboutthe NTP associations.
Usage guidelines
When a device is operatingin NTP broadcast or multicast server mode, the display ntp-service
sessions command does not display the IPv4 NTP association information corresponding to the
broadcast or multicast server. However,the associationsare counted in the total number of
associations.
Examples
# Displaybrief information aboutall IPv4 NTP associations.
<Sysname>display ntp-service sessions
source reference stra reach poll now offset delay disper
********************************************************************************
[12345]LOCAL(0) LOCL 0 1 64 - 0.0000 0.0000 7937.9
[5]0.0.0.0 INIT 16 0 64 - 0.0000 0.0000 0.0000
Notes: 1 source(master), 2 source(peer), 3 selected, 4 candidate, 5 configured.
Total sessions: 1
Table 15 Command output
Field Description
source
• When the reference clock is the local clock, the field displaysLOCAL
(number). It indicates that the IP address of the local clock is
127.127.1.number, where number represents the NTP process
number in the range of 0 to 3.
• When the reference clock is the clock of another device, the field
displays the IP address of the NTP server. If this field displays0.0.0.0,
the IP address of the NTP server has not been resolved successfully.
To Next Page
Loading...
Need help?
General
