458
Default
The upper limit for IPv6 NetStream entries is 10000.
Views
System view
Predefined user roles
network-admin
Parameters
max-entries: Specifies the upper limit for IPv6 NetStream entries that the cache can accommodate.
The value range is 1000 to 100000.
Usage guidelines
(Distributed devices in standalone mode.) The max-entries argument takes effect on each card.
(Distributed devices in IRF mode.) The max-entries argument takes effect on each card of each IRF
member device.
(Centralized devices in IRF mode.) The max-entries argument takes effect on each IRF member
device.
If you execute the ipv6 netstream max-entry max-entries command multiple times, the most recent
configuration takes effect.
Examples
# Set the upper limit to 5000 for IPv6 NetStream entries.
<Sysname> system-view
[Sysname] ipv6 netstream max-entry 5000
ipv6 netstream timeout active
Use ipv6 netstream timeout active to set the aging timer for active flows.
Use undo ipv6 netstream timeout active to restore the default.
Syntax
ipv6 netstream timeout active minutes
undo ipv6 netstream timeout active
Default
The aging timer is 30 minutes for active flows.
Views
System view
Predefined user roles
network-admin
To Next Page
Loading...
Need help?
General
