139
the end interface number. If an interface in the specified range does not support PoE, it is ignored
when the PoE profile is applied.
Examples
# Apply the PoE profile named forIPphone to GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] apply poe-profile name forIPphone interface gigabitethernet 1/0/1
# Apply the PoE profile with index number 1 to PIs GigabitEthernet 1/0/2 to GigabitEthernet 1/0/8.
<Sysname> system-view
[Sysname] apply poe-profile index 1 interface gigabitethernet 1/0/2 to gigabitethernet
1/0/8
Related commands
apply poe-profile
display poe-profile interface
display poe device
Use display poe device to display general PSE information.
Syntax
Distributed devices in standalone mode/centralized devices in IRF mode:
display poe device
Distributed devices in IRF mode:
display poe device [ chassis chassis-number ]
Centralized devices in IRF mode:
display poe device [ slot slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
chassis chassis-number: Specifies an IRF member device by its member ID. If you do not specify a
member device, the command displays information about all PSEs in the IRF fabric. (Distributed
devices in IRF mode.)
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, the command displays information about all PSEs in the IRF fabric. (Centralized devices in
IRF mode.)