450
Default
IPv6 NetStream sampling is disabled.
Views
Interface view
Predefined user roles
network-admin
Parameters
inbound: Enables IPv6 NetStream sampling in the inbound direction.
outbound: Enables IPv6 NetStream sampling in the outbound direction.
sampler sampler-name: Specifies a sampler by its name. The name is a case-insensitive string of 1
to 31 characters.
Examples
# Use sampler abc for inbound IPv6 NetStream sampling on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] ipv6 netstream inbound
[Sysname-GigabitEthernet1/0/1] ipv6 netstream inbound sampler abc
ipv6 netstream aggregation
Use ipv6 netstream aggregation to specify an IPv6 NetStream aggregation mode and enter its
view.
Use undo ipv6 netstream aggregation to remove the configuration for an IPv6 NetStream
aggregation mode.
Syntax
ipv6 netstream aggregation { as | bgp-nexthop | destination-prefix | prefix | protocol-port |
source-prefix }
undo ipv6 netstream aggregation { as | bgp-nexthop | destination-prefix | prefix |
protocol-port | source-prefix }
Default
No IPv6 NetStream aggregation mode is specified.
Views
System view
Predefined user roles
network-admin
To Next Page
Loading...
Need help?
General
