330
Usage guidelines
Use SNMP-Notification event monitor policies to monitor variables in SNMP notifications.
EAA executes an SNMP-Notification event monitor policy when the value of the monitored variable in
an SNMP notification meets the specified condition.
You can configure only one event for a monitor policy. If the monitor policy already contains an event,
the new event replaces the old event.
Examples
# Configure a CLI-defined policy test to monitor SNMP notifications that contain the variable OID
1.3.6.1.4.1.25506.2.2.1.1.2.1.0. Enable the system to drop an SNMP notification and execute the
policy if the variable in the notification contains the user name admin.
<Sysname> system-view
[Sysname] rtm cli-policy test
[Sysname-rtm-test] event snmp-notification oid 1.3.6.1.4.1.25506.2.2.1.1.2.1.0 oid-val
admin op eq drop
event syslog
Use event syslog to configure a Syslog event for a CLI-defined monitor policy.
Use undo event to delete the event in a CLI-defined monitor policy.
Syntax
event syslog priority priority msg msg occurs times period period
undo event
Default
No Syslog event is configured.
Views
CLI-defined policy view
Predefined user roles
network-admin
Parameters
priority priority: Specifies the lowest severity level for matching log messages. The level argument
can be an integer in the range of 0 to 7, or the word all, which represents any severity level from 0 to
7. A lower number represents higher priority level. For example, specify a severity level of 3 to match
log messages from level 3 to level 0.
msg msg: Specifies a regular expression to match the message body, a string of 1 to 255 characters.
The log message must use the Hewlett Packard Enterprise format. For more information about log
message formats, see "Configuring the information center."