430
Usage guidelines
You can configure different source interfaces in different NetStream aggregation mode views.
If no source interface is configured in NetStream aggregation mode view, the source interface in
system view applies.
Examples
# In system view, specify GigabitEthernet 1/0/1 as the source interface for NetStream traditional data
packets.
<Sysname> system-view
[Sysname] ip netstream export source interface gigabitethernet 1/0/1
# In AS aggregation mode view, specify GigabitEthernet 1/0/2 as the source interface for NetStream
aggregation data packets.
<Sysname> system-view
[Sysname] ip netstream aggregation as
[Sysname-ns-aggregation-as] ip netstream export source interface gigabitethernet 1/0/2
Related commands
ip netstream aggregation
ip netstream export v9-template refresh-rate packet
Use ip netstream export v9-template refresh-rate packet to configure the refresh frequency (in
packets) for NetStream version 9 templates. The templates are sent after the specified number of
packets are sent.
Use undo ip netstream export v9-template refresh-rate packet to restore the default.
Syntax
ip netstream export v9-template refresh-rate packet packets
undo ip netstream export v9-template refresh-rate packet
Default
Version 9 templates are sent every 20 packets.
Views
System view
Predefined user roles
network-admin
Parameters
packets: Specifies the number of packets that are sent before version 9 templates are sent to
NetStream servers for an update. The value range is 1 to 600.
To Next Page
Loading...
Need help?
General
