78
Views
ICMP echo operation view
Predefined user roles
network-admin
Parameters
ipv6-address: Specifies the source IPv6 address for probe packets. IPv6 link-local addresses are not
supported.
Usage guidelines
If you execute the source interface and source ipv6 commands for an ICMP echo operation
multiple times, the most recent configuration takes effect.
The specified source IPv6 address must be the IPv6 address of a local interface. The local interface
must be up. Otherwise, no probe packets can be sent out.
Examples
# In ICMP echo operation view, specify 1::1 as the source IPv6 address for ICMP echo requests.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] source ipv6 1::1
Related commands
source interface
source port
Use source port to configure the source port number for probe packets.
Use undo source port to restore the default.
Syntax
source port port-number
undo source port
Default
The source port number is not specified.
Views
SNMP/voice operation view
UDP echo operation view
UDP jitter operation view
UDP tracert operation view
To Next Page
Loading...
Need help?
General
