HPE D6020

To replace the component, reverse the removal procedure.
Removing and replacing the D6020 power block
To remove the component:
1. Power down the D6020 (see “Powering down” (page 18)).
2. Disconnect all cables.
3. Remove all power supplies (see “Removing and replacing the D6020 power supply”
(page 24)).
4. Remove all fan modules (see “Removing and replacing the D6020 fan” (page 22)).
5. Remove all I/O modules (see “Removing and replacing the hot-pluggable I/O module”
(page 23)).
6. Release the hard drive drawers:
a. Pull down the handle on the front of the drawer, but do not extend the drawer.
b. Push up and hold the two release mechanisms on the I/O bays, and then move the
drawer forward about 15 cm (6 in).
Figure 11 Pushing up the release mechanism on the I/O bays
Figure 12 Moving the hard drive drawer forward
Removing and replacing the D6020 power block 25