Need help?Do you have a question about the HPE BladeSystem c7000 and is the answer not in the manual?
General| Form Factor | 10U |
|---|---|
| Interconnect Bays | 8 |
| Blade Slots | 16 half-height or 8 full-height |
| Device Bays | 16 half-height blade server bays or 8 full-height blade server bays |
| Power Supplies | Up to 6 hot-plug power supplies |
| Cooling Fans | 10 hot-plug fans |
| Management | Onboard Administrator |
| Height | 17.5 inches |
| Width | 17.6 inches |
| Compatibility | HPE ProLiant and Integrity server blades |
| Non-operating Temperature | -40° to 70°C (-40° to 158°F) |
| Operating Humidity | 10% to 90% (non-condensing) |
| Non-operating Humidity | 5% to 95% (non-condensing) |
| Networking | Dependent on installed interconnect modules |
| Operating Temperature | 10° to 35°C (50° to 95°F) |
Diagram illustrating the numbering for full-height device bays.
Diagram illustrating the numbering for half-height device bays.
Diagram illustrating the numbering for power supply bays.
Diagram illustrating the numbering for fan bays.
Steps for configuring single-phase power for the enclosure.
Steps for configuring three-phase power for the enclosure.
Configuring network connectivity and settings for the Onboard Administrator with KVM.
To Next Page
