4. Slide the batter packs out slowly on a flat and stable surface. Use two hands to support the batter packs.
5.
Verify that the new battery has the same ratings as the battery being replaced.
6.
To make sure that there is proper connection, firmly push the new battery pack into the UPS.
7. Reinstall the battery cover.
8. Insert the four screws and secure them to the front panel.
9. Install the front center cover.
10. Test the batteries. For more information, see
Battery test.
Updating the UPS firmware
To update the UPS firmware, see the Hewlett Packard Enterprise website.
Maintenance
38
To Next Page
Loading...
