To Next PageTo Next Page
Need help?Do you have a question about the HPE G2 R6000 and is the answer not in the manual?
General| Form Factor | Rack-mountable |
|---|---|
| Battery Type | Sealed Lead-Acid (SLA) |
| Nominal Output Voltage | 230 V |
| Frequency | 50/60 Hz |
| Input Voltage | 200 V AC to 240 V AC |
| Output Voltage | 200 V AC to 240 V AC |
| Interface | USB |
| Capacity | 6000 VA |
| Battery Runtime | Varies based on load (typically 5-15 minutes at full load) |
Lists essential safety warnings and considerations for UPS installation.
Step-by-step guide for physically mounting the UPS into the rack.
Procedures for properly connecting the UPS battery modules.
Steps to safely connect the UPS to the primary power source.
Requirements and procedures for hardwiring the UPS power input.
Instructions for connecting external equipment to the UPS outputs.
Process for charging the UPS batteries after initial installation.
Information and procedures for conducting UPS battery tests.
Steps to enable power delivery to the connected equipment.
How to charge the batteries for the Extended Runtime Module.
Instructions for adjusting various UPS operational parameters.
Steps to safely shut down the UPS and its connected loads.
Procedure for removing and replacing the main UPS unit.
Procedure for removing and replacing the Extended Runtime Module.
Guidance on how to perform firmware updates for the UPS.
Troubleshooting steps for when the UPS is in bypass mode.
Addresses symptoms and solutions for low battery warnings.
Troubleshooting steps for issues related to absent or disconnected batteries.
Explains battery fault conditions and provides resolution steps.
Troubleshooting for scenarios where the UPS does not provide expected runtime.
Actions to take when the UPS capacity is exceeded by connected loads.
How to diagnose and resolve issues related to UPS overheating.
Solutions for scenarios where the UPS fails to power up.
