To Next Page

To Previous Page

ERM rear panel components

Item Description

1 ERM to UPS connector

2 ERM recognition port

USB communications port

NOTE: This port is only used for firmware upgrades. To update the UPS firmware, see the Hewlett Packard

Enterprise website.

Dry contact port

CAUTION: Before using the dry contact port, the following cautions must be observed:

• The relay output contacts cannot be connected to any utility circuits.

• Reinforced insulation to the utility is required.

• The relay output contacts have a maximum rating of 250VAC/5A.

The UPS has four relay outputs. Each relay output is available with either an open or closed contact.

Component identification 9

Other manuals for HPE G2 R6000

Questions and Answers:

Need help?

Do you have a question about the HPE G2 R6000 and is the answer not in the manual?

General

Form Factor	Rack-mountable
Battery Type	Sealed Lead-Acid (SLA)
Nominal Output Voltage	230 V
Frequency	50/60 Hz
Input Voltage	200 V AC to 240 V AC
Output Voltage	200 V AC to 240 V AC
Interface	USB
Capacity	6000 VA
Battery Runtime	Varies based on load (typically 5-15 minutes at full load)