HPE G2 R6000 User Manual

Maintenance
Replacing the UPS
Procedure
1. Power down all attached load devices.
2. Power down the UPS.
3. Unplug the UPS power cord.
4. Disconnect all cabling.
5. Remove the screws securing the UPS to the rack.
6. Remove the UPS from the rack.
To replace the component, reverse the removal procedure.
Replacing the ERM
Procedure
1. Disconnect all ERM cabling.
2. Remove the screws securing the ERM to the rack.
3. Remove the ERM from the rack.
To replace the component, reverse the removal procedure.
Updating the UPS firmware
To update the UPS firmware, see the Hewlett Packard Enterprise website.
30 Maintenance

HPE G2 R6000 Specifications

General

Form Factor	Rack-mountable
Battery Type	Sealed Lead-Acid (SLA)
Nominal Output Voltage	230 V
Frequency	50/60 Hz
Input Voltage	200 V AC to 240 V AC
Output Voltage	200 V AC to 240 V AC
Interface	USB
Capacity	6000 VA
Battery Runtime	Varies based on load (typically 5-15 minutes at full load)