HPE G2 R6000 User Manual

Installation
Precautions
Save these instructions. This document contains important safety instructions that must be followed during
installation, operation, and maintenance of the UPS and batteries.
WARNING: A risk of personal injury from electric shock and hazardous energy levels exists. The
installation of options and routine maintenance and service of this product must be performed by
individuals who are knowledgeable about the procedures, precautions, and hazards associated with AC
power products.
48 106
This symbol indicates that the UPS exceeds the recommended weight for one
individual to handle safely.
68 150
This symbol indicates that the ERM exceeds the recommended weight for one
individual to handle safely.
WARNING: To reduce the risk of personal injury or damage to the equipment, observe local
occupational health and safety requirements and guidelines for manual material handling.
WARNING: To prevent personal injury from earth conductor leakage current:
• Do not operate the UPS while disconnected from the utility power source.
• Disconnect load devices before disconnecting the UPS from the utility power source.
Preparing to install the hardware
Before installing the hardware:
1. Be sure the necessary tools and materials are available.
2. Select an installation site.
3. Prepare the equipment for installation in the rack.
Tools and materials
The following tools are required for installation:
Phillips screwdriver
The following items are supplied with the UPS:
Installation 13

HPE G2 R6000 Specifications

General

Form Factor	Rack-mountable
Battery Type	Sealed Lead-Acid (SLA)
Nominal Output Voltage	230 V
Frequency	50/60 Hz
Input Voltage	200 V AC to 240 V AC
Output Voltage	200 V AC to 240 V AC
Interface	USB
Capacity	6000 VA
Battery Runtime	Varies based on load (typically 5-15 minutes at full load)