Main menu Submenu Display information or menu function
Reset average
power
Clears average power usage measurement
Reset cumul.
power
Clears cumulated power usage measurement
Dry contacts test Tests dry contact relay outputs
Settings Local settings Sets product general parameters
In/Out settings Sets output parameters
On/Off settings Sets on/off conditions
Battery settings Sets battery configuration
Event log Event filter Selects faults, alarms, and events to display
Event list Displays the events stored
Reset event list Clears events
Fault log Fault list Displays the faults stored
Reset fault list Clears faults
Identification — Product type, serial number, UPS firmware, communication card IPv6,
communication card MAC, detected accessories
Register
product
— Links to the HPE registration website
Verifying the RPO port connection
NOTE: While testing, operate connected equipment in a safe test mode so the effects do not disrupt critical
operations.
Prerequisites
Connect the RPO port.
Procedure
1. Initiate an RPO by closing the RPO contact.
2. Verify proper connection of the RPO port.
a. Power up the UPS by pressing the Power button.
b. Disconnect the RPO port.
c. Reconnect the RPO port.
d. Verify that the UPS remains in Online mode.
Operations 27
To Next Page
Loading...
Need help?
General
