HPE R1500

881627-002 Edition 3
Page 7
ENGLISH
1. Overview
1.2 Weights and dimensions
Description Weights
(lb/kg)
Dimensions (in/mm)
D x W x H
HPE R1500 G5 NA 44 / 20 21.8 x 17.2 x 1.7 / 554 x 437 x 43
HPE R1500 G5 JP/TWN UPS 44 / 20 21.8 x 17.2 x 1.7 / 554 x 437 x 43
HPE R1500 G5 INTL UPS 43 / 19.5 21.8 x 17.2 x 1.7 / 554 x 437 x 43
1.3 Rear panels
HPE R1500 G5 NA UPS and HPE R1500 G5 JP/TWN UPS
2 1 48 73 9 6b5
6a
HPE R1500 G5 INTL UPS
6a
2 1 473 6b
5
8
NOTE: The HPE G5 UPSs have 3 programmable output load
segments.ThesearedenedasGroup1,Group2,andPrimary
Group.Theloadsegments/groupscanbeconguredviasoftware
and the unit’s user interface. For advice on configuration through
software, see the HPEPP software or the Hewlett Packard
Enterprise networking device documentation. To configure the
UPS through the front panel, see "2.4 User settings".
Load Groups 1 and 2 can be programmed to switch off/on
independently. The Primary Load Group controls the outlets
indicated and initiates a unit shutdown. The Primary Load Group
is intended for the most critical loads.
(1) USB communication port
(2) RS-232 communication port
(3) Slot for optional communication
card
(4) Connector for ROO (remote
on/off) or RPO (remote power off)
control
(5) Outlets for connection of critical
equipment (Primary group)
(6a) Group 1: programmable outlets for
equipment connection
(6b) Group 2: programmable outlets for
equipment connection
(7) Attached 6 ft input power cord for
AC power source
(8) LED indicating site wiring fault
alarm
(9) Ground screw
(1) USB communication port
(2) RS-232 communication port
(3) Slot for optional communication
card
(4) Connector for ROO (Remote
on/off) or RPO (Remote Power off)
control
(5) Outlets for connection equipment
(Primary group)
(6a) Group 1: programmable outlets for
equipment connection
(6b) Group 2: programmable outlets for
equipment connection
(7) Socket for connection to AC power
source
(8) Ground screw