HPE StoreOnce 5200,
5250, and 5650 Systems
Start Here Guide
©
Copyright 2018 Hewlett Packard Enterprise Development LP
*BB954-80010*
Part Number: BB954-80010
Published: September 2018
Edition: 1
Abstract
This guide describes how to install a basic HPE
StoreOnce 5200, 5250, or 5650 System that does not
include optional storage products. The StoreOnce
System can then be fully configured using the
StoreOnce Management Console, as described in the
HPE StoreOnce 3620, 3640, 5200, 5250, and 5650
Systems Installation Guide.
Use this guide when installing a basic system without
optional storage products and with all PCIe cards pre-
installed. PCIe cards that were ordered with the system
are pre-installed.
Use the HPE StoreOnce 3620, 3640, 5200, 5250, and
5650 Systems Installation Guide in the following cases.
• The system includes optional storage products or
capacity upgrade kits.
• The system arrived without PCIe cards pre-installed
or requires additional PCIe cards.
Process overview
Required tools:
• Torx T25 screwdriver
• A monitor and USB keyboard or a KVM for initial
network configuration
Procedure
1. Verify contents
2. Record the iLO default network information
3. Verify installation requirements
4. Install the components in the rack 5200 or 5250 or
5650
5. Attach the security bezel
6. Connect the storage enclosure cables
7. Connect the system cables
8. Power on the system
9. Configure iLO during bootup (optional)
10. Configure the basic network
11. Configure the StoreOnce System
Verifying contents
The StoreOnce System includes a server node and the
base storage enclosure.
Procedure
1. Verify that you received the server components.
• StoreOnce server node
• Rail kit
• Security bezel
Page 1
To Next Page
Need help?
General
