Troubleshooting
18
Call Us: (800)215-0894
Notes:
Contact Us!
Product Information & Sales: (800)215-0894 x 1
Order Status & Tracking: (800)215-0894 x 2
Technical Support: (800)215-0894 x 3
Temperature display shows 000
number
This could either be an issue with the
computer gauge or heat sensor wire.
There is a wire that connects directly
from the heating element and into
your temperature gauge. If this wire
is damaged, loose, or disconnected,
your temperature display will show
either 000 or HH.
• Start by disconnecting the large green connector
behind your computer gauge and connecting it
back in. Sometimes if this is slightly loose, you will get
that error reading.
• If you’re facing the temperature gauge directly from
behind, the two wires on the bottom right corner
are your heat sensor wires. If you route them to the
other side, they should go directly into your heating
element. Make sure this wire is tightly connected.
• Try disconnecting them and reconnecting it just to
be sure they’re tightly connected.
• If problem persists, you will need to replace the heat
sensor wire.
Phillips Screw Driver
• To open the back
panel.
• To unscrew ans
screw the wire for
the heat sensor
wire
5 Minutes
Auto Open model does not
pop open when it is done
counting down
All auto open models are supposed to
open on their own when the timer has
completed counting down. The gas
shocks installed are supposed to push
your upper platen up very much like
the shocks on a car trunk.
• Turn your machine off completely and start by
closing down the lid while it is off.
• If your machine doesn’t pop up, then start
increasing the pressure knob to the right until it pops
up on its own.
• If your are noticing that the machine doesn’t pop
up even when the pressure is set heavy, then try
lifting the handle upwards and see if the platen
stays up or if it falls down.
• If your platen falls down, then your gas shocks have
failed and will need to be replaced.
N/A 1-3 Min
To Next Page
Loading...
