D35 User Manual
Rev：1.0
3.4.4 Label learning
In the following cases, users can learn label location so that printers can better locate labels:
●
The printer is installed and used for the first time;
●
The printer is used for the first time after the sensor is cleaned;
● Re-use the printer after it has not been in use for a long time;
●
Replacement of new types of roll paper;
●
In the process of printing, the printer can not effectively identify the mark;
● The use environment of printer has changed greatly.
Label location learning method:
1.Manual label location learning:
When the printer is ready, press Feed button until the blue light flashes for the second
time,release Feed button, then the printer will learn the seam label mode; until the blue light
flashes for the third time,release Feed button, then the printer will learn the black label mode.
When the printer learns in continuous paper mode, the learning is invalid.
2.Complete the learning through the printer Utility tool software:
Users can omplete the learning through the printer Utility tool software,see the details
in”Chapter 6 Label Printer Utility Instructions”.
Note:
After the learning is completed, you can reopen the printer cover and re-place the blank label
paper that you have just learned in case of the cost of paper.
To Next Page
Loading...
