D35 User Manual
Rev：1.0
3.4.5 Printer test
When you initially install the printer or have any problems with the printer, you can execute the
self-test program and confirm the following status. Firmware version, printer parameter setting
status, print quality and external equipment related setting information, after self-check to
confirm that there is no problem with the printer, please check other devices or software. This
function runs independently from other devices or software.
1.Printing Manually
1) Make sure the power is connected and that the roll paper is loaded properly.
2) Make sure the top cover and mechanism of the printer are closed properly. Then turn on the
printer.
3) When the printer is ready, press the feed button. As soon as the indicator flashes (green)
once, loosen the button. Then the printer starts to print the self-test page.
2.Printing by Windows Driver Program
1) Install the Windows Driver program.
2) Please set the
“
Interface
”
as the type you use.
3) Use the Windows Driver Program to print out the
“
Self-test page
”
.
Please refer to “Chapter 7 Windows Driver Instructions” for more detailed information.
To Next Page
Loading...
