HRESYS TL Series User Manual

TL-LFP Series liFePO
4
Battery Operation Manual
7
Installation of Battery Modules
1) Installation and fixation
Battery modules of TL-LFP series are applicable to installation in 19-inch cabinets and
wall-hanging.
 19inch cabinet installation
Insert battery module into 19 inch cabinet, and fix two handles of battery module with
cabinet rack using 4pcs M6 screws.
 Wall-hanging installation
Wall-hanging installation also can be adopted, fix two handles of battery module with
triangle rack on the wall using 4pcs M6 screws.
2) Ground connection
 GND screw in front panel of battery is connected with ground through a flexible cable
no less than 6AWG.
3) Battery output connection
 Before connect battery power cable, open the circuit breaker of the rectifier which
controls the battery circuit and make sure the circuit is disconnected.
 Connect ‘+’ of Battery Output with positive copper bus bar of power plant, and ‘-’ with
negative copper bus bar.
 If multi battery modules will be connected in parallel, connect ‘+’ of Battery Output of
each battery module with positive copper bus bar of power plant, and ‘-’ with negative

HRESYS TL Series Specifications

General

Brand	HRESYS
Model	TL Series
Category	Camera Accessories
Language	English