Why is my HS Racks & Stands boom drifting?
Boom drifting can occur if the fittings are not plumb. In this case, you should shim between the supporting structure and fittings accordingly. Another cause can be misaligned fittings, so ensure you align the fitting holes properly.
What to do if my HS 311 does not rotate smoothly?
If your equipment does not rotate smoothly, this could be due to debris in the bearings. Remove any debris that you find. Misaligned fittings can also cause this issue, so make sure to align the fitting holes properly.
How to fix HS Racks & Stands that does not rotate a complete rotation?
If your crane boom does not complete a full rotation, it's likely due to an obstruction. Remove any obstructions that may be present.
Details the product code structure for the tie rod jib, including model, capacity, and span.
Explains the product code for the fitting kit, covering model and fitting style.
Definitions of common terms used to specify and design jib cranes.
Steps before assembly, ensuring structural and clearance requirements.
Attaching wall brackets to the support structure.
Bolting fittings, tie rods, and inserting pivot bolts.
Checking plumbness, greasing, and installing rotation/end stops.
Instructions for assembling and installing the tight wire kit.
Itemized list of components for the tight wire assembly.
Overview of operator responsibilities, safety warnings, and required qualifications.
Mentions relevant OSHA, ANSI, and ASME standards to be read.
Lists what the operator MUST do for safe operation.
Lists what the operator MUST NOT do to prevent hazards.
Specific operating procedures for the jib boom movement.
Schedule and procedures for inspecting various crane components.
Procedure for overall crane inspection and reporting issues.
Recommends lubrication frequency based on crane usage.
Specifies lubricants for roller bearings based on temperature.
Provides common issues, their causes, and recommended solutions for the jib crane.
Details the warranty coverage for manual rotation jib and gantry cranes.
Explains exclusions and conditions that void the warranty.
Guidance on providing serial numbers when ordering replacement parts.
Visual identification of major components for Model 311.
Table listing part numbers, descriptions, and quantities.
General| Brand | HS |
|---|---|
| Model | 311 |
| Category | Racks & Stands |
| Language | English |
To Next Page