ONLY COMPETENT ERECTION PERSONNEL FAMILIAR WITH STANDARD FABRICATION PRACTICES
SHOULD BE EMPLOYED TO ASSEMBLE HANDLING SYSTEMS CRANES BECAUSE OF NECESSITY IN
INTERPRETING THESE INSTRUCTIONS. HANDLING SYSTEMS IS NOT RESPONSIBLE FOR QUALITY
OF WORKMANSHIP PERFORMED DURING CRANE INSTALLATION.
WARNING
ALL HANDLING SYSTEMS EQUIPMENT IS NOT DESIGNED FOR OR MADE FOR TRANSPORTING HU-
MANS. FAILURE TO COMPLY WITH ANY ONE OF THE LIMITATIONS STATED IN THIS CRANE MAN-
UAL CAN RESULT IN PROPERTY DAMAGE, INJURY, OR DEATH. PLEASE TAKE ALL NECESSARY
PRECAUTIONS DURING INSTALLATION.
WARNING
CONSULT WITH A QUALIFIED STRUCTURAL ENGINEERED TO DETERMINE IF YOUR SUPPORT
STRUCTURE IS ADEQUATE TO SUPPORT THE LOADS GENERATED BY ANCHOR BOLT FORCE,
OVERTURNING MOMENT, OR AXIAL LOAD OF YOUR CRANE.
WARNING
CRANE CANNOT BE UTILIZED AS A GROUND: A SEPARATE GROUND WIRE IS REQUIRED.
WARNING
DO NOT MODIFY CRANE IN ANY WAY. ANY ALTERATIONS DONE IN THE FIELD WITHOUT CONSENT
FROM HANDLING SYSTEMS WILL VOID ALL WARRANTY.
WARNING
KEEP HANDS
CLEAR OF
ROTATING
PARTS!
DANGER
OVERLOADING AND IMPROPER USE CAN RESULT IN INJURY
WARNING
• MANUAL MUST BE FULLY READ AND
UNDERSTOOD BY QUALIFIED ERECTION
PERSONNEL PRIOR TO INSTALLATION AND USE
OF PRODUCT.
• CRANE IS NOT DESIGNED FOR AND SHOULD
NOT BE USED FOR LIFTING OR TRANSPORTING
HUMANS
• CRANE CAN NOT BE UTILIZED AS A GROUND.
• DO NOT FIELD MODIFY CRANE IN ANY WAY
• CONSULT WITH QUALIFIED STRUCTURAL ENGINEER
TO DETERMINE IF JIB CRANE SUPPORT STRUCTURE
IS ADEQUATE BASED ON THE LOADS GENERATED BY
THE JIB CRANE
WARNING
To Next Page
Loading...