HT7051 - HT7051N
EN - 8
5 OPERATING INSTRUCTIONS
5.1 SWITCH ON THE INSTRUMENT
After switch on, the instrument gives a short
acoustic signal and, for approximately one
second, all segments of the display appear.
Then, the instrument shows the firmware
version, then it sets to the last measuring
mode selected before turning off.
5.1.1 Auto Power OFF
If no test is being carried out, the instrument automatically turns off after approximately 5
minutes after the last time a key was pressed. To reactivate the instrument, it is necessary
to turn it on again by pressing the relevant key.
To Next Page
Loading...
Need help?
General
