HT IRONMETER User Manual

IRONMETER
EN - 11
4.3.5. Capacitance measurement
CAUTION
Before carrying out capacitance measurements on circuits or capacitors, cut
off power supply from the circuit being tested and let all capacitance in it be
discharged. When connecting the multimeter and the capacitance to be
measured, respect the correct polarity (when required).
Fig. 7: Use of the instrument for capacitance measurement
1. Select position CAP
2. Press the MODE/ key to select “nF” measurement
3. Insert the red cable into input terminal VHz%mACAP and the black cable
into input terminal COM
4. Position the leads at the ends of the capacitor to be tested, respecting, if necessary,
the positive (red cable) and negative (black cable) polarity (see Fig. 7). The display
shows the value of capacitance
5. The message “O.L.” indicates that the value of capacitance exceeds the maximum
measurable value
6. To use the HOLD function, see § 4.2

HT IRONMETER Specifications

General

Brand	HT
Model	IRONMETER
Category	Multimeter
Language	English