Safety
HTC 500
8 1.0
Note!
For the CE marking to be valid, the instructions in this manual
must be followed.
Note!
The machine should be stored in a dry, warm (plus degrees)
location when not in use.
Note!
If the machine is stored in a cold (minus degrees) location, it must
be placed in a warm (plus degrees) location for at least two hours
before use.
Note!
The appropriated dust extractor must be used when dry grinding.
Contact HTC for model recommendation.
Note!
After removing glue and wet grinding, always lift up the grinding
heads so that they do not stick to the floor and damage machine
components and the floor when restarting.
Note!
When wet grinding, the water tank must be filled with water. Only
cold water with no chemical additives may be used.
To Next Page
Loading...
